Publicidad
Idiomas disponibles
Idiomas disponibles
BENDING CONDUIT
Bending ½", ¾", 1", and 1 ¼" EMT, Rigid, and IMC Conduit
1. Before preparing the MSB2000 for bending conduit, ensure that the bender is disconnected from the
power source.
2. Install the correct roller assembly on the bender and attach the hinge pin to secure it to the bender.
Insert the cotter pin into the end of the hinge pin.
3. Install the appropriate bending shoe for the conduit being bent. Place the black roller assembly in the
folded-up or vertical position. These rollers are used when bending ½", ¾", 1", and 1 ¼" conduit.
MSB2000 with Roller Supports in the UP-position for bending ½", ¾", 1", and 1 ¼" conduit.
5. Using your foot, lift up on the pressure pedal to position the 1 ½" & 2" roller unit into the fully retracted
position. The 1 ½" and 2" rollers should drop into the fully retracted position. If they do not fully retract,
use a tool, such as a screwdriver, to adjust the roller so that both rollers rotate counterclockwise to the
retracted position. Using a tool to adjust the roller will keep hands and fingers clear from any potential
pinch points. These pressure rollers are not used when bending ½", ¾", 1", and 1 ¼" conduit.
0 0
SOUTHWIRE.COM | 11
Publicidad
