Southwire MAXIS MSB2000I Manual De Instrucciones página 14

8. Turn the power switch on the back of the bender to the ON position.
9. Using the pendant controller, press FWD to rotate the shoe clockwise. Rotate the shoe until the 1
½" and 2" half of the shoe is facing down and the painted hook on the shoe is at approximately
the 6 o'clock position. On the protractor scale, the arrow should be approximately 5° before the 0°
starting point.
10. Facing the front of the bender, load the conduit into the right side of the bender. Place the
conduit on the correct size roller and guide it into the bender until it aligns with the corresponding
groove in the shoe.
11. Press FWD and rotate the shoe until the bottom of the hook fully contacts the bottom of the
conduit. The conduit should be held firm but you should still be able to turn it with your hand. The
arrow on the protractor scale should be at approximately the 0° position.
CAUTION
Ensure there is enough room between back of hook and front of pressure roller to allow pressure
roller to fully engage into the stop as shown in picture below. Failure to do so will result in
unacceptable bends.
14 | SOUTHWIRE.COM
For EMT and IMC Conduit
INCORRECT
CORRECT