Publicidad
Idiomas disponibles
Idiomas disponibles
SETUP AND OPERATION
1. Before assembling the MSB2000, ensure that the bender is disconnected from the power source.
2. Mount the handle using the four(4) hex bolts and washers. The bolts & washers can be found in the
fabric pouch hanging on the MSB2000 frame.
3. Mount the appropriate roller support onto the legs of the bender. The roller support mounts as shown
below. The roller support is heavy and has spring-loaded moving parts so use caution to prevent
pinching your hands and fingers.
4. The IMC and EMT roller supports have a trap plate that may require adjustment to properly fit under the
leg of the bender. See diagram below. The distance between the trap plate and leveling screws should
be approximately 3.1" (78mm). If necessary, loosen the two set screws, adjust the leveling bolts so the
trap plate fits under the leg of the bender, then retighten the set screws.
8 | SOUTHWIRE.COM
Hex Bolts
2 per side
MSB2000 With Roller Support Installed
Leveling
Screw
3.1"
(78 mm)
Trap
Plate
Publicidad
