Publicidad
Idiomas disponibles
Idiomas disponibles
HANDLE REMOVAL AND REPLACEMENT
The handle of the MSB2000 is designed to be removable. This feature is convenient when performing
complex bending and makes it easy to replace a damaged handle.
Removal
1. Place the bender in the upright position.
2. Remove the two bolts from both sides of the handle
3. Lift the handle to remove.
Replacement
1. Align the holes in the handle with the holes in the bender.
2. Replace the bolts on left and right side of handle.
3. Tighten both bolts to the handle until snug.
The only proper way to lift this bender is by attaching a nylon or polyester sling around the shoe
storage shaft. The sling should extend between the handle and main frame of the bender so that the
handle acts as a guide for the sling.
Make sure that all components used to lift this bender are properly rated for the 109 kg (241 lb.)
weight. Use a ramp to load and unload from a truck or other vehicle that is not equipped with a lift
gate.
WARNING
Make sure the handle is properly installed with tightening bolts before lifting or moving the bender.
An improperly installed handle could allow the bender to fail, injuring nearby personnel.
FAILURE TO OBSERVE THIS WARNING COULD RESULT IN SEVERE INJURY OR DEATH.
Troubleshooting
Problem
Bender will not operate.
Bends are overbent a few degrees.
Sides of conduit are smashed
Bends are under-bent a few degrees.
Rippling defects
20 | SOUTHWIRE.COM
Probable Cause
No voltage.
Loose pendant cable connection
Not properly adjusted for spring back
Too much squeeze on 1-1/2" or 2"
EMT or IMC conduit.
Not properly adjusted for spring back Determine how many degrees you
Too little squeeze on 1-1/2" or 2" EMT
or IMC conduit.
Possible Remedy
Check supply voltage circuit opera-
tion.
Check that switch is on.
Ensure that the pendant cable is
securely connected to the bender and
the pendant
Determine how many degrees you are
overbent and subtract an equivalent
amount from your bend
Reduce roller pressure. See Section
titled "Adjusting the 1 ½" & 2" Pres-
sure Rollers"
are under bent and add an equivalent
amount more to your bend
Increase roller pressure. See Section
titled "Adjusting the 1 ½" & 2"
Pressure Rollers"
Publicidad
