Publicidad
Idiomas disponibles
Idiomas disponibles
OFFSET BEND
1. Measure the height and length of the obstruction. Select the angle to be used.
2. See the Offset Table. The height of the obstruction must be equal to or greater than the minimum
offset.
3. Refer to the X Table to find the X dimension. Refer to the Offset Table to find the center-to-center
distance.
Note: If the center-to-center distance is not shown, calculate it by using the multipliers shown in the
Offset Table.
4. Mark the conduit as shown.
5. Insert the conduit into the bender. Align Mark 1 with the front edge of the hook and bend the
conduit.
6. Return the bender to approximately 5° before 0°. Advance the conduit forward and align Mark 2
with the front edge of the hook.
7. Make the second bend.
Offset Table
OFFSET
15°
Max.Conduit Size
Center-to-Center
30°
Max.Conduit Size
Center-to-Center
45°
Max.Conduit Size
Center-to-Center
OFFSET
15°
Max.Conduit Size
Center-to-Center
30°
Max.Conduit Size
Center-to-Center
45°
Max.Conduit Size
Center-to-Center
OFFSET ANGLE
MULTIPLIER
Figures are approximate.
X Table
CONDUIT SIZE
"X"
LENGTH
MARK 1
HEIGHT
2
3/4
7-3/4
12
46-3/8
24
1-1/2
16-15/16
CENTER TO CENTER DISTANCE-OFFSET HEIGHT X MULTIPLIER
10°
15°
5.8
3.9
1/2
3/4
3-1/16
3-1/16
x
CENTER
TO
DISTANCE
LENGTH
OBSTRUCTION
4
1-1/2
15-7/16
3/4
8
14
54-1/16
28
19-13/16
22-1/2°
2.6
1
3-3/16
MARK 2
6
2
23-3/16
30-15/16
1
1-1/2
12
1/2
8-1/2
11-5/16
16
18
2
61-13/16
69-9/16
2
32
36
2
22-5/8
25-7/16
30°
2.0
1-1/4
1-1/2
4
4-1/4
8
10
38-5/8
2
16
20
1
1-1/4
14-1/8
20
22
77-1/4
85
40
44
28-1/4
31-1/8
45°
1.4
2
4-1/2
SOUTHWIRE.COM | 19
Publicidad
