Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT SAFETY INFORMATION
SAFETY ALERT
SYMBOL
This symbol is used to call your attention to hazards
or unsafe practices which could result in injury or
property damage. The signal word, defined below,
indicates the severity of the hazard. The message
after the signal work provides information for
preventing or avoiding the hazard.
Immediate hazards which, if not avoided, WILL result
in severe injury or death.
Hazards which, if not avoided, COULD result in
severe injury or death.
Hazards or unsafe practices which, if not avoided,
MAY result in severe injury or death.
Electrical Shock Hazard:
• Inspect the power cord before use.
Repair or replace the cord if
damaged.
• Connect the power cord to a 120-
volt, 20 amp receptacle on a ground-
fault protected circuit only. Refer to
"Grounding Instructions."
• Do not modify the power cord or
plug.
• Disconnect the unit from power
before servicing.
For continued protection against risk of fire and electric
shock, replace ONLY with same manufacturer, type, and
rating of fuse.
• Keep guards in place and in working
order.
• Remove any tools from bender
before operating. Form habit of
checking to see that all tools are
removed from bender before turning
it on.
FAILURE TO OBSERVE THESE WARNINGS COULD RESULT IN
SEVERE INJURY OR DEATH.
4 | SOUTHWIRE.COM
DANGER
WARNING
CAUTION
WARNING
WARNING
WARNING
Read and understand all of the
instructions and safety information
in this manual before operating or
servicing this tool. Failure to observe
this warning could result in severe
injury or death.
Do not use this tool in a hazardous
environment. Hazards include
flammable liquids, gases, or other
materials. Using this tool in a
hazardous environment can result in
a fire or explosion. Failure to observe
this warning could result in severe
injury or death.
Do not use in a dangerous
environment. Do not use power tools
in damp or wet locations, or expose
them to rain. Keep work area well-
lighted.
• Do not immerse the pendant switch
in water or any other liquid. Failure to
observe these warnings could result
in severe injury or death.
Always use safety glasses. Everyday
glasses only have impact resistant
lenses; they are NOT safety glasses.
When using in dusty environment, use
a face or dust mask.
WARNING
• Reduce the risk of unintentional starting. Make sure
switch is in off position before plugging in.
• Never leave tool running unattended. Turn power off.
Do not leave tool until it comes to a complete stop.
• Disconnect tools before servicing and when changing
accessories such as shoes, rollers, and the like.
Accidental start-up could result in serious injury.
Failure to observe these warnings could result in severe
injury or death.
WARNING
Never stand on tool. Serious injury could occur if the tool
is tipped.
• Do not overreach. Keep proper footing and balance at
all times.
DANGER
DANGER
WARNING
WARNING
Publicidad
