ADEO Services 04010G03 Manual De Instrucciones página 129

FR
5. INSTALLATION AND ASSEMBLY
The electrical installation must be carried out by a person qualified to work with electrical
equipment. This appliance can be used by children aged 8 years or older and persons with
ES
reduced physical, sensory or mental capabilities or lack of experience or knowledge if
they are properly monitored or if they have been instructed to use the device safely and
understand the risks involved. User cleaning and maintenance must not be carried out by
PT
- Do not allow children or adults to sit or lean on the equipment. Children should be
supervised to ensure that they do not play with the equipment.
IT
- Our pumps can only be assembled and installed in pools or basins that comply with HD
384.7.702.
If in doubt, please consult your specialist.
EL
- Mount the pump horizontally thanks to the pre-filter. The pumps are equipped with a
pre-filter with a basket inside to collect large particles, as they could damage the hydraulic
part inside the pump.
PL
- All pumps are equipped with a foot with holes for anchoring to the ground (see assembly
steps).
RU
- Connect the pump terminals to the corresponding pipes, tightening them firmly with
the clamps. (see assembly steps).
KZ
- Install the pump below water level in the pool to improve the performance of the pump.
- Where a self-priming pump is to be installed above the water level, the pressure difference
at the pump inlet shall not exceed 0,02 MPa (2mH2O), ensuring that the inlet hose is as short
UA
as possible, because a longer hose would increase the suction time and pressure drops of the
installation.
- Make sure the pump is protected from flooding and has dry ventilation.
RO
- It is essential to use a multiple disconnection device with a gap of at least 3 mm
BR
between the surfaces to disconnect the equipment from electrical current.
- The electrical installation must be carried out by a person qualified to work with
electrical equipment. This equipment is not intended for persons with physical, sensory
HE
or mental disabilities or inexperienced persons unless they do so under the supervision or
instruction for use of a person responsible for their safety.
- Do not allow children or adults to sit or lean on the equipment. Children should be supervised
to ensure that they do not play with the equipment.
AR
- Set the value of the thermal relay appropriately according to the pump current.
- Use a motor housing with magneto-thermal protection (see assembly steps).
- Follow the conditions of installation and electrical connection. Otherwise, the pump
EN
manufacturer may decline any responsibility and render the warranty null and void.
- The installation may be subject to special requirements
children without supervision.
PIPING
LOCATION
ELECTRICAL INSTALLATION
129