Descargar Imprimir esta página

GE Profile PFDS450 Manual Del Propietario E Instalación página 40

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
Instructions
STACKING THE WASHER AND DRYERlif desired}
BEFORE YOU BEGIN
Read these instructions
completely
and carefully.
. IMPORTANT- Save t hese i nstructions
for
local electrical
inspector's
use.
, IMPORTANT
-
Observe
all governing
codes and ordinances.
, Note
to
Installer
-
Be sure
to
leave
these
instructions
with the Consumer.
, Note to Consumer
- Keep these instructions
for
future reference.
, Service must be performed
by a qualified installer.
, Proper
installation
is the
responsibility
of the
installer.
FOR YOUR SAFETY:
A WARNING
Electric Shock Hazard. Disconnect
power before
installing.
Failure to do so could result in serious
injury or death.
Potential
Personal Injury. More than two people
are recommended
to lift the dryer into position
because of its weight
and size. Failure to do so
could result in personal
injury or death.
Avoid
Tipping
and Rupture
of Utility
Services.
Dryer must be securely
attached
to the washer.
DO NOT place the washer
on top of the dryer.
Failure to do so could result in personal
injury/
death or property damage.
Hobile Home or Hanufactured
Home Installation
- Stacking
of a gas dryer is not permitted
in a
mobile home or manufactured
home.
MINIMUM
CLEARANCE OTHER THAN
ALCOVE OR CLOSET INSTALLATION
Minimum
clearance
to combustible
surfaces
and
for air opening
are: 0" both sides, 1" front
and
3" rear. Consideration
must
be given
to provide
adequate
clearance
for installation
and service.
REOUIREMENTS FOR ALCOVE OR
CLOSET INSTALLATION
, Your dryer
is approved
for
installation
in an
alcove or closet, as stated on a label on the dryer
back.
o The dryer MUST be vented to the outdoors.
See
the EXHAUSTING THE DRYERsection.
o Minimum
clearance
between
dryer cabinet
and
adjacent walls or other surfaces is:
0" either side
3" front and rear
, Minimum
vertical
space from floor to overhead
shelves, cabinets, ceilings, etc., is 52".
, Closet
doors
must
be Iouvered
or otherwise
ventilated
and have at least 60 square
inches
of open area equally
distributed.
If the closet
contains
both a washer and a dryer, doors must
contain a minimum
of 120 square inches of open
area equally distributed.
, The closet should
be vented to the outdoors
to
prevent gas pocketing
in case of gas in the supply
line.
, No other fuel-burning
appliance
shall be installed
in the same closet with the dryer (gas models
only).
NOTE: WHEN THE EXHAUST DUCT IS LOCATED AT
THE REAR OF THE DRYER, MINIMUM
CLEARANCE
FROM THE WALL IS 5.5 INCHES.
40

Publicidad

loading