Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
@
PREPARE THE PEDESTAL
Pull the drawer
out as far as it
will go.
Remove
screws from
drawer slides.
Slide drawer
out of the
/
base and set
aside.
FOR DRYERS ONLY:
D
Locate
the 4 support
pads
from
the
parts
package.
Each pad has 2 protrusions
that fit
into the holes on top of the pedestal. Press the
rubber pads into each set of corner
holes on
the top of the pedestal as shown.
II
@
NOTE: The support
pads should be installed on the
dryer only. DO NOT INSTALL THESE PADS ON THE
WASHER PEDESTAL.
[]
@
D
INSTALL THE PEDESTAL TO THE
WASHER
OR DRYER
Place the pedestal against
the bottom
of the
unit. Check to be sure the drawer front is at the
front of the washer.
Align the holes in the pedestal with the holes in
the bottom of the unit. Use a Phillips screwdriver
to install the 4 bolts through
the pedestal and
into the unit-do
not tighten.
Slide the pedestal
toward
the unit, until it is
aligned
front
to back. Use a 7 mm socket
wrench to securely tighten the bolts.
44
Publicidad
