GE Profile PFDS450 Manual Del Propietario E Instalación página 47

Before you call for service... GEAppliances.co
PROBLEM
Time Remaining
jumped to a
lower number
Possible Causes
The estimated time may change
when a smaller load than usual
is drying
What To Do
, This is normal.
Cannot make a
selection and the
dryer beeps twice
The DRYNESS LEVEL, T EMP
or OPTIONthat you are
trying to select is incompatible
with the chosen dry cycle
, This is normal.
Dryer is running but
O0 is displayed in
Time Remaining
The EXTEND TUMBLE
option was chosen
. This is normal. During extended tumbling, the time
remaining is not displayed. The extended tumbling
option lasts approximately 20 minutes.
Clean Lint Filter (message)
POWER button was activated
. PressSTART/PAUSE to begin a dry cycle and the message
will disappear.
Dryer doesn _ heat
Fuse is blown/circuit breaker
is tripped; the dryer may tumble
but not heat
Check the building's fuse/circuit breaker box and
replace both fuses or reset both breakers. Your dryer
may tumble if only one fuse is blown or one breaker
tripped.
Gas service is off
. Hake sure gas shutoff at dryer and main shutoff are
fully open.
LP gas supply tank is empty
or there has been a utility
interruption of natural gas
(gas models)
Refillor replace tank. Dryer should heat when utility
service is restored.
Inconsistent drying times
Type of heat Drying time will vary according to the type of heat used.
If you recently changed from an electric to a gas
(natural or LP)dryer, or vice versa, the drying time
could be different.
Type of load and . The load size,types of fabric, wetness of clothes and the
drying conditions length and condition of the exhaust system will affect
drying times.
Glow at the rear Heaters behind the drum . This is normal. Under certain drying conditions and
of the drum room ambient lighting, the glow of the heaters may be
visible at the rear of the drum.
Clothes are still wet The door was opened mid-cycle. . A dry cycle must be reselected each time a new load
and dryer shut off The load was then removed from is put in.
after a short time
the dryer and a new load put in
without selecting a new cycle
Small load . When drying 3 items or less,choose SPEEDDRYor
TIMEDDRY.
Load was already dry except . Choose SPEEDDRY or TIMEDDRYto dry damp collars
for collars and waistbands and waistbands. In the future, when drying a load with
collars and waistbands, choose MOREDRY.
Dryer is not level . Move dryer to an even floor space or adjust leveling legs
as necessary until even.
Clothes are wrinkled
Overdrying
. Select a shorter drying time.
. Remove items while they still hold a slight amount of
moisture. Select a LESSDRYor DAMP setting.
Letting items sit in dryer after . Remove items when cycle ends and fold or hung
cycle ends immediately, or use the EXTENDTUNBLEoption.
Overloading . Separate large loads into smaller ones.
47