Publicidad
Idiomas disponibles
Idiomas disponibles
EGEA TECH
8.3.1 Environmental conditions for operation
The device cannot operate in
rooms classified as environ-
ments with an explosive atmos-
PROHIBITION
phere or at risk of fire.
The general operation of the de-
vice is guaranteed by observing
the environmental conditions in-
ATTENTION
dicated.
The equipment has not been de-
signed to be installed outdoors
but to be used in a "closed" envi-
ATTENTION
ronment not exposed to the ele-
ments with an ambient tempera-
ture between +4 °C / +43 °C.
To avoid the risk of freezing, if
the appliance is installed in an
area subject to temperatures lo-
wer than those indicated, when
it is not electrically powered, the
water present in the tank must be
emptied. Empty it as described in
the appropriate chapter.
For the correct operation of the device it is necessary that its
positioning meets the following requirements:
• away from heat sources,
• away from direct sunlight,
• away from air conditioning systems,
• in a dust-free environment.
The environmental conditions for operation are shown in the
table below.
Ambient external air temperature (min. / max.)
4 °C / +43 °C
8.3.2 Physical characteristics of water
The Langelier index of the water, measured at the operating
temperature, must be between 0 and +0.4
The device must not operate with water hardness of less than
12°F. Conversely, if the water hardness is very high (over
25°F), use a suitably calibrated and monitored water softener,
because the residual hardness must not drop below 15°F.
200 HT - 260 HT
cod. 3540000420 - Rev. 03 - 09/2023
NB: In the design and construc-
tion phase of the plants, the ap-
plicable local regulations and
OBLIGATION
provisions must be complied
with.
8.4
PREPARATION OF THE INSTALLATION SITE
Proper operation affects the life of the device and its compo-
nents, but above all it affects the efficiency of the system. We
recommend that you carefully follow the instructions below; our
Technical Assistance Office is available for any clarifications on
the matter.
In the planning and construction
phases of the systems, the stan-
dards and regulations in force lo-
OBLIGATION
cally must be complied with.
The equipment must be installed
and operated by a qualified tech-
nician in accordance with local
health and safety legislation and
regulations.
Incorrect installation can cause
damage to property and injury to
people and animals; the manu-
facturer declines all responsibili-
ty for the consequences.
The air inlet and outlet of the
appliance must be ducted as in-
dicated in the paragraph 8.6 on
page 171.
The product must be installed in a suitable place, i.e. to allow
normal use and adjustment operations as well as routine and
extraordinary maintenance.
The place where it will be operated must, therefore, be pre-
pared according to the values shown in fig. 48.
EN
169
Publicidad
