Door Opening - Imesa IM6 Instrucciones De Uso

E030101C
push will allow a fast forward. A longer push will
allow ti skip a full cycle; in this case, machine will
stand-by until "START" .
If you wish to interrupt programme, please push
"STOP". In this case, programme will be stopped
and terminated. It will be possible to open the
door once the safety self-controls will be carried
out by the microprocessor.
During these self-controls, display will show:
"STOP –WAIT".
At the end of procedure, display will show "END"
and it will be possible to open the door.
10. SOAKING
It is possible to stop the phases of pre-wash,
wash and rinse, in order to have a soak-wash.
Drum will stop with water load as long as required.
To activate soak-washing push "START" for 5
seconds. Display will show "SOAK" and its
residual time flowing on.
11. MODIFYING
TEMPERATURES.
It is possibile to alter such parameters during
machine operations. Alterations will not affect the
memory and will be cancelled at the end of
programmes. If decisive alterations are required,
please refer to programming. (see §16).
Procedure to make these changements (instantly
but temporary) here below:
During machine operations, please push "MENU".
LEVELS, TIMES,
Programme no. will disappear and a parameter
subject to alteration will appear; by pushing
MENU more times, all parameters enabled to
modifications will flow.
"TEMP" modification of final temperature
of running cycle
"LIV" modification of final water level of
running cycle
"VEL" modification of drum revolving
speed
"TIME" modification
times
mot. 1 40
PREWASH 1
One or more parameters may NOT appear by
pushing "MENU" if alteration of the parameter is
not allowed in that moment (for instance it is not
possibile to modify temperature if washer is
spinning.)
Moreover, every parameter has a range min./max.
(i.e. it is not possibile to increase drum rotation to
99 rpm if machine is washing).
To carry-out alterations, it is enough to push "+"
and "-" on the switch-board while parameter to be
altered is displaied
Every time "+" and "-" are pushed, values will be
increased or decreased. To speed-up alteration,
please push on "+" and "-".

12. DOOR OPENING

Door may be opened after microprocessor has
carried-out safety self-controls; display will show
"END", please then push "DOOR OPENING" to
release lock.
22
30/11/2003
of running
25° 2
TEMP. 40
27:24
cycle