Kichler Ample 310354 Manual De Instrucciones página 11

HANGING THE FAN (continued)
Close-To-Ceiling Installation
Step 1. Pass the 120-volt supply wires through the center hole in
the ceiling mounting bracket as shown in Fig. 5.
Step 3. Secure the ceiling mounting bracket to the ceiling outlet
box with the screws and washers provided with your outlet box.
Step 2. Remove the canopy cover from the canopy by pushing
out (Fig. 10A).
Step 4. Remove three of the six screws and lock washers (every
other one) from the top of the motor assembly (Fig. 10B). Retain
screws and lock washers.
Step 5. Place the gasket, then the decorative ring, then the
canopy over the coupling at the top of the motor assembly. Align
the holes in the canopy and gasket with the holes in the top of
the motor assembly and fasten the gasket and the canopy to the
motor assembly using the screws and lock washers that were
removed in Step 4. (Fig. 10B).
Step 6. Tighten the screws securely (Fig. 10B).
WARNING: Failure to completely tighten the three
screws in Step 6 could result in fan loosening and
possibly falling.
Step 7. Hang the fan on the hook of the ceiling mounting bracket.
Be certain that the canopy is fully locked into hook as shown in
Fig. 11. This will allow you to make the electrical connections.
Screws and Lock
Washers
(3 of 6 places)
Canopy
Gasket
Coupling
Motor
Assembly
Fig. 10B
Canopy Cover
Fig. 10A
Decorative
Ring
Hook
Ceiling Mounting Bracket
54" Ample | 11
Canopy
Fig. 11