A.BAttery Removal; B.FOotplate Adjustment - Quickie Freestyle M11 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

I X . S e t - U p , A d j u s t m e n t & U s e
A. BATTERY REMOVAL
(Figures 1, 2 & 3)
To remove the batteries for transporting or servicing:
1. Remove Batteries
a. Remove seat following instructions in section IX, D. Seat Removal.
b. Remove battery access panel by inserting a flat head screw driver between the panel
and main shroud toward the back of the panel at the word "open".
c. Push the screw driver forward until the panel lifts off.
d. Unplug and remove batteries from rear of chair.
e. Lift up batteries by lifting up on battery straps.
2. Battery Installation
See Section XI. Batteries, D for installation and wiring diagram.
Batteries may weigh up to 55 lbs. Care must be taken to avoid injury when lifting
up on battery straps.
B. FOOTPLATE ADJUSTMENT
The single footplate can be adjusted in three different ways: height, length, and angle.
1. Height Adjustment (Figures 4 & 5)
(6 possible adjustments):
a. Remove pin (A) (Figure 5)
b. Move footplate to desired height and slide it into slot B (Figure 4).
c. Re-install pin (A) (Figure 5) through desired hole.
2. Length Adjustment (Figure 5)
(3 possible adjustments):
a. Remove pin (C).
b. Move footplate to desired length.
c. Re-install pin (C) through desired hole.
3. Angle Adjustment (Figure 6)
Adjust bolt (D) until desired angle is reached.
E n g l i s h
1
2
3
4
B
5
C
A
6
D
21
930583 Rev. F

Publicidad

Tabla de contenido
loading

Tabla de contenido