Operating Guide; A.PErformance Control Settings; B.INtegral Joystick - Quickie Freestyle M11 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

26
A. PERFORMANCE CONTROL SETTINGS (M11 AND F11)
1. It is vital to match control settings to your level of function and ability.
2. Consult your health care professional and your supplier to select the best control set-
tings for you.
3. Check and adjust the settings every six to twelve months (or more often, if needed).
4. Adjust the control settings immediately if you notice any change in
your ability to:
• Control the joystick.
• Hold your torso erect.
• Avoid running into objects.
5. Control Settings are adjusted through the use of the Quickie QTRONIX Programming
Pad. See your supplier if you do not own a Quickie QTRONIX Programming Pad.
B. INTEGRAL JOYSTICK
(Figure 1)
1. To Connect
a. Line up receptacle on large rectangular connector (Beau Connector) and AMP connec-
tor located behind the seat with the pins on the connecter located on the joystick
harness.
b. Push in firmly.
2. To Disconnect
Pull up on beau connector until it disconnects from the frame mounted receptacle, located
behind the seat. Pinch the sides of the AMP connector and then pull.
3. Operation
The standard integral joystick controls the chair's performance. It consists of the following
parts:
Speed Control or Drive Mode Selection Buttons (A and B)
To decrease the speed level depress button A. Or, when 1- 5 Drive modes are programmed,
depress button A to activate lower drive mode(s).
To increase speed level, depress button B. Or, when 1- 5 Drive modes are programmed,
depress button B to activate higher drive mode(s).
Speed level active, or Drive Mode selected, is indicated on display (C) by a series of five
lights. One light indicates slowest level/mode currently active, while five lights indicates
highest level/mode currently active.
Battery Charge Indicator (D)
• Green lights indicate that batteries are fully charged.
• Yellow lights indicate that batteries need recharging.
• When the lights stay in the red band, the batteries must be recharged.
On/Off Button (E)
Turning the chair on or off is accomplished by depressing button E.
Horn (F)
930583 Rev. F
E n g l i s h
X. OPERATING GUIDE
X . O p e r a t i n g G u i d e
D
E
F
B
G
H
C
A
Integral Joystick
1

Publicidad

Tabla de contenido
loading

Tabla de contenido