Seat Height Adjustment; D.SEat Removal; Shroud Removal - Quickie Freestyle M11 Manual De Instrucciones

22
C. SEAT HEIGHT ADJUSTMENT
(Figure 7–Mount for power tilt shown)
1. Remove pins (A) from all four seat mount posts.
2. Select the desired seat height (rear seat mount should never be more then one posi-
tion lower then the front).
3. Reinsert the pins.
Ensure both front seat posts are positioned to the same height. Rear seat posts
should also be set to the same height.
D. SEAT REMOVAL (Seat and Rehab Seat Frame)
1. Remove Seat
(Figures 8 & 9)
a. Unplug controller connections at the back of the seat.
b. Remove safety lock-out pin (B).
c. Pull the two seat release levers upward
d. Tilt seat backward slightly
e. Pull the forward seat and remove.
f. When replacing the seat into the mounts, ensure you do not pinch your fingers.
E. SHROUD REMOVAL
The plastic protective shroud can be removed for adjustment or servicing.
1. Remove Colored Shroud
Two removable colored shroud covers are Velcro
remove, simply peel the colored shroud off of the main shroud as shown in Figure 10.
2. Remove Main Shroud
a. Remove both brake releases by unscrewing the front connection and pulling them
out. (Figure 11)
b. Lift the middle shroud assembly off.
3. Replace Main Shroud
Replace shroud by reversing above instructions.
930583 Rev. F
E n g l i s h
-ed on to the sides of the main shroud. To
®
I X . S e t - U p , A d j u s t m e n t & U s e
7
A
8
B
9
10
11