Remote Joystick Assembly - Quickie Freestyle M11 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

X . O p e r a t i n g G u i d e
Joystick (G)
The joystick controls the direction and speed of your chair. Turn the chair on and move the
joystick in the direction you want to go.
• Moving the joystick from the neutral (center) position disengages the motor locks,
allowing the chair to move.
• The chair will move faster the more you move the joystick away from neutral.
NOTE– If your speed becomes hard to manage, release the Joystick and the chair will come to a com-
plete stop.
• When you release the joystick it will return to neutral; the chair will slow to a stop
and the motor locks will reengage.
• We recommend that you switch the chair off if you stop for any length of time. This
will conserve battery power.
NOTE– Once the chair stops, switching the chair off will not affect the motor locks.
Joystick Boot (H)
Make sure the boot is not torn or cracked (this could allow debris, water or moisture to
enter). If the boot is torn or cracked, replace it as soon as you can.
C. REMOTE JOYSTICK
(Figure 2)
1. To Connect
a. Line up female cylindrical connector (F) with its male receptacle on the end of the
power cable (G).
b. Push in firmly.
2. To Disconnect
Pull back on the retaining ring of the cylindrical connector (F) until it disconnects from the
power cable (G).
3. To Adjust the height of the remote joystick
(Figure 3)
a. Remove the two pan-head screws (A), securing the angle bracket mount (B).
b. Remove the joystick from the mount by unfastening the two screws (C) on the under-
side of the mount.
c. Position angle bracket mount such that you achieve the desired joystick height. Four
positions are available by relocating the mount either on the top or bottom of the
mounting bar (D) and/or by rotation of the angle bracket mount.
4. swing-away retractable mount (optional) (Figure 4)
The joystick is mounted with a mechanism which allows the control to be locked in a for-
ward or retracted position.
Adjustment
a. To retract joystick, press firmly on inside of joystick (E).
b. Push joystick away from front of armrest until it locks into retracted position.
c. To return to forward position, pull to release magnetic catch and swing.
d. Tension adjustment can be made by tightening through bolt (F).
E n g l i s h
2
G
F
3
B
A
C
D
4
E
F
27
930583 Rev. F

Publicidad

Tabla de contenido
loading

Tabla de contenido