AEG BSE798380B Manual De Instrucciones página 233

Problems with cleaning procedure
Description
There is dirty water on the bottom of
the cavity after descaling.
There is too much water on the bot‐
tom of the cavity after cleaning.
Cleaning performance is not satis‐
factory.
Power cut always stops cleaning. Repeat
cleaning if it's interrupted by power failure.
Problems with Wi-Fi signal
Possible cause
Trouble with wireless network signal.
New router installed or router configuration changed.
The wireless network signal is weak.
The wireless signal is disrupted by another microwave
oven placed near the appliance.
12.2 How to manage: Error codes
When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Possible cause
The grill -/ roasting pan is on a
wrong shelf position.
You put too much detergent in the
appliance before you started clean‐
ing.
You started cleaning when the appli‐
ance was too hot.
You did not remove all the accesso‐
ries from the appliance before
cleaning.
Check if your mobile device is connected to the wire‐
less network.
Check your wireless network and router.
Restart the router.
To configure appliance and mobile device again, refer
to "Before first use" chapter, Wireless connection.
Move router as close to the appliance as possible.
Turn off the microwave oven.
Avoid using another microwave oven and the Remote
Control of the appliance at the same time. Microwaves
disrupt Wi-Fi signal.
Remedy
Remove the remaining water and
the descaling agent from the bottom
of the appliance. Next time put the
grill -/ roasting pan on the first shelf
position.
Next time evenly spread the thin lay‐
er of a detergent on the cavity walls.
Wait until the appliance is cold. Re‐
peat cleaning.
Remove all the accessories from the
appliance. Repeat cleaning.
Remedy
ENGLISH 233