Publicidad
Idiomas disponibles
Idiomas disponibles
Preheating the espresso machine
Plug the power cord of coff ee machine into the socket. When all indicator lights
turn on for 1 second and then turn off , the coff ee machine enters the standby
state. Press the power switch once, the indicator light of the "On/Off " button
remains on, and the espresso machine enters the self-test program to check
whether the NTC is normal. If the NTC is normal, it starts to warm up, and the
three indicator lights of "Espresso", "Froth/Cappuccino" and "Latte" begin to
fl ash. When the temperature reaches the set point, the warm-up is over and all
indicator lights remain on, signifying that the coff ee machine is ready to use.
Note: When the self-test program that checks the NTC is abnormal, the
corresponding indicator lights will fl ash at the same time (see the protection rules
for details) with the buzzer beeping for 5 seconds when the coff ee machine cannot
work. In this state, the button is invalid and the machine will automatically enter
standby mode after 30S of alarm with all indicator lights going out.
Making espresso
After the coff ee machine is preheated, put the required coff ee powder (7-8g for
a small cup, approximately 14-15g for a large cup and pressing the powder with
a force of 150 N into the fi lter cup. Place the fi lter cup containing tightly-pressed
coff ee powder into the designated position of the funnel, and then rotate the
funnel into the designated position of the coff ee machine. Press the "Espresso"
button once, and wait for 5 seconds. Then, the indicator light of "Espresso" in
small cup will fl ash, while the indicator lights of other coff ee functions will be
half lit. At this time, the coff ee machine will start making a small cup of coff ee.
Or press the "Espresso" button twice, and wait for 5 seconds. Then, the indicator
light of "Espresso" in large cup will fl ash, while the indicator lights of other coff ee
functions will be half lit. At this time, the coff ee machine will start making a large
cup of coff ee. After the coff ee is made, the buzzer sounds once.
Make sure that the small indentation on the small
fi lter (20) or big fi lter(21) is located above the inden-
tation on the funnel holder (22) when inserted.
Then turn the small fi l-
ter (20) or big fi lter(21)
slightly to ensure it
cannot fall out.
EN
37
Publicidad
