Publicidad
Idiomas disponibles
Idiomas disponibles
Before Use
EN
1. Remove the protective strips
2. Install the side brush
Click
Note: Install the side brush until it clicks into place.
3. Set up the charging dock
Peel off the double-sided tape at the bottom of the charging dock,
then place the dock on the level ground against the wall and
connect it to a power outlet.
9
＞ 0.5 m
Note:
· Keep the immediate area 1.5m in front of the charger and 0.5m to both sides of the
charging dock clear of objects.
· To ensure you can connect to the robot with your phone well, make sure the robot and
charging dock are within Wi-Fi range.
· Do not place the charging dock in an area with direct sunlight or where other objects
might block the signal, as this may hinder the robot from returning to the charging dock.
· Use of the double-sided tape depends on your need.
· Please clean the floor area where the charging dock will be placed with a dry rag.
· If necessary, remove the double-sided tape slowly to reduce adhesive residue.
4. Place the robot onto the charging dock to charge
Note:
· Fully charging is recommended before first-time use.
· Do not install the mopping module while charging. Be extra careful with the wet mop
as it can damage the floor.
＞ 0.5 m
＞ 1.5 m
Battery Level Indicator
• White: Battery level is more than 15%
• Orange: Battery level is less than 15%
Publicidad
