Publicidad
TROUBLESHOOTING GUIDE
If the system does not seem to operate as it should, after re-reading these operating instructions carefully, check the chart below:
i
Symptom
|
Causes
Solutions
Power does not turn on.
¢ The flat cables are not connected properly.
* Correct the connections.
There is no sound.
¢ The power cord is not connected properly.
* Correct the connection.
« An incorrect FUNCTION select button is pressed.
* Press the FUNCTION
select button to select the
correct input.
¢ There is a bad connection between units.
» Correct the connection.
¢ There is a short circuit in the speaker jack.
* Disconnect the power cord, correct
the condition,
* The breaker has tripped because of a connection to a
including speaker connections, and connect the
low-impedance speaker.
power cord again.
Sound comes from only
¢ A speaker is disconnected.
* Correct the speaker connection.
one speaker.
* The balance is off-center.
*
Turn the BALANCE control knob to the centre position.
There is constant, wave-
« The antenna is not connected properly.
* Check the antenna connection.
* The station is not correctly tuned.
like static.
* Correct the tuning.
° The signal is too weak.
*
Install an outside antenna.
* The system is picking outside noise.
¢ Change the location or direction of the antenna.
* Turn the system to a different orientation.
¢ Move the system away from other electrical
appliances, such as a TV, fluorescent lights, or
move the appliances.
The sound is distorted.
* There is multipath distortion.
* Change the orientation of the antenna..
* Replace the antenna with one that has the correct
orientation.
The display is strange.
* The microprocessor has been electronically affected. | » Reset the microprocessor. Turn off the power with
the MEMORY button pressed down. (All stored
settings will be erased from the system.)
* Change the setting to properly receive the input
signal from the CD. First, turn off the power on the
amplifier. Then, with the CD function button
pressed down, turn it back on.
The tape does not play.
* Deck 2 is paused.
¢ Press fl PAUSE to release the pause.
The sound is off-balance.
* The head is dirty.
° Clean the head.
- |
The high sounds are too
* The Dolby NR mode is set differently from when the | * Reset the Dolby NR.
loud.
recording was done.
There are no high
+ Anon-Dolby NR tape is being played back inthe Dolby | * Turn off the Dolby NR.
3
frequencies.
NR mode.
There is noise.
The CD function stored by
* The setting on the amplifier to receive the input signal
the Al FUNCTION is not
code from the CD player is incorrect.
activated.
* The head is dirty.
| ¢ Clean the head
* The erasure prevention tab on the tape has been | * Cover the erasure prevention hole with cellophane
removed.
tape.
'
* There is an incorrect connection.
* Correct the connection
+ The head is dirty.
* Clean the head properly.
The tape is not erased.
¢ The erasure head is dirty.
¢ Clean the erasure head.
There is no recording.
GC. _sette
deck
47
Publicidad
