Craftsman 126.32561 Manual Del Operador página 23

(Fig. M2)
450 Bevel Stop Adjustment
NOTE: Ensure that the 33.90 Crown Molding
Pin is in its disengaged (outer) position.
6. Use an Allen Key to turn the screw in or
out to adjust the blade angle.
7. Return the Cutting Head to its upright
position and recheck angular alignment
against the combination square.
8. Repeat steps 1 to 7 until correct angular
alignment is achieved.
9. Tighten the Bevel Angle Adjustment Screw
Iocknut securely.
1. Loosen the Bevel Lock Handle and tilt the
Cutting Head completely to the left until it
rests against the 450 stop.
2. Use a combination square to see if the
blade is at 450 to the table.
3. If the saw blade is not in exact alignment
adjustment is necessary.
4. Return the Cutting Head to its upright
position.
5. Loosen the Iocknut on the 450 Bevel
Adjustment Screw.
6. Use an Allen Key to turn the Adjustment
Screw in or out as required. (Fig. N)
0° Bevel Pointer Adjustment
NOTE: The operator must be satisfied that
the blade is exactly perpendicular to the table
when in the upright position and against its
stop.
1. If the pointer is not in exact alignment
with the 0° mark on the protractor scale
adjustment is necessary.
2. Loosen the Bevel Pointer screw using a #2
Phillips screwdriver.
3. Adjust the Bevel Pointer so that it is in
alignment exactly with the 0° mark.
4. Retighten the screw.
(Fig. N)
7. Tilt the Cutting Head to the 45 osetting and
recheck for alignment with the combination
square.
8. Repeat steps 1 to 7 until the correct
angular alignment is achieved.
9. Tighten the Adjustment Screw Iocknut
securely once alignment is achieved.
23