Craftsman 126.32561 Manual Del Operador página 3

MOTOR
Power Source ................................................................................................... 120V, 60Hz, 13A
Speed ......................................................................................................... 4800RPM (No Load)
Brake ............................................................................................................................... Electric
Double Insulated .................................................................................................................... Yes
BLADE SIZE
Diameter ............................................................................................................................. 10 in.
Arbor size .......................................................................................................................... 5/8 in.
Blade Type ......................................................................... 40T TCT (Tungsten Carbide Tipped)
ROTATING TABLE
Diameter ....................................................................................................................... 11-3/4 in.
CUTTING CAPACITY- LUMBER
At 90 o......................................................................................... Max Section 2-7/8 in x 5-1/2 in.
At 45 o......................................................................................... Max Section 2-7/8 in x 4-1/4 in.
At Compound Bevel (45 ox 45 °) ........................................................ Max Section 2 in x 4-1/4 in.
[,_ WARNING l
To avoid electrical hazards, fire hazards or damage to the tool, use proper circuit
protection.
This tool is wired at the factory for 110-120 Volt operation.
It must be connected to a 110-120 Volt / 13 Ampere time delay fuse or circuit breaker.
To avoid shock or fire, replace power cord immediately if it is worn, cut or damaged in
any way.
Before using your tool, it is critical that you read and understand these safety rules.
Failure to follow these rules could result in serious injury to you or damage to the tool.
3