Craftsman 126.32561 Manual Del Operador página 39

[_ DANGER 1
To avoid injury, never put lubricants on
the blade while it is spinning.
[_ WARNING 1
To avoid fire or toxic reaction, never
use gasoline, naphtha, acetone,
lacquer thinner or other similar highly
volatile solvents to clean the miter
saw.
To avoid injury from unexpected
starting or electrical shock, unplug
the power cord before working on the
saw.
For your safety, this saw is double-
insulated. To avoid electrical shock,
fire or injury use only parts identical
to those identified in the schematic
diagram.
when removed from the machine.
Run new brushes without load for
approximately 5 minutes. This will help
the break-in process.
TOP BRUSH
POSITION
BOTTOM
BRUSH
POSITION
CHECKING AND REPLACING CARBON
BRUSHES (Fig. KK)
(Fig. KK) Diagrams show top and bottom
brush caps.
Replace both carbon brushes if either has
less than 1Ain. length of carbon remaining, or
if the spring or wire is damaged or burned.
To remove the brushes:
Unscrew the plastic caps found at the
back of the motor. Be careful as the
caps are spring-loaded.
Withdraw the brushes with their springs.
If replacement is necessary insert new
brushes and replace the caps.
NOTE: Used but serviceable brushes can
be replaced, but only as long as they are
inserted into the same position as they were
LOWER BLADE GUARD
1,_. WARNING]
Do not use the saw if the Lower Blade
Guard is damaged or not operating correctly.
A damaged or non-functioning guard
must be replaced before the saw is used.
A replacement guard must be tested for
efficient and safe procudure with the machine
disconnected from the power source. The
guard operates automatically as the Cutting
Head is raised or lowered.
39