Craftsman 126.32561 Manual Del Operador página 6

ALWAYS wear Safety Goggles
(not glasses) that comply with
ANSI Safety standard Z87.1.
Everyday eyeglasses have only impact
resistant lenses.
They ARE NOT safety glasses.
Safety Goggles are available at Sears.
NOTE: Glasses or goggles not in compliance
with ANSI Z87.1 could seriously injure you
when they break.
13. WEAR A FACE MASK OR DUST MASK.
Sawing operations can produce dust.
14. SECURE WORK.
O Use clamps or a vice to hold work
when practicable.
It is safer than using your hand and it frees
both hands to operate the toot.
15. DISCONNECT TOOLS FROM
POWER SOURCE before servicing, and
when changing accessories such as
blades, bits and cutters.
16. REDUCE THE RISK OF
UNINTENTIONAL STARTING.
Make sure switch is in the OFF position
before plugging the tool in.
17. USE RECOMMENDED ACCESSORIES.
Consult this Operator's Manual for
recommended accessories.
The use of improper accessories may cause
risk of injury to yourself or others.
18. NEVER STAND ON THE TOOL.
Serious injury could occur if the cutting tool
is unintentionally contacted.
19. CHECK FOR DAMAGED PARTS.
Before further use of the tool, a guard or
other part that is damaged should be carefully
checked to determine that it will operate
properly and perform its intended function -
check for alignment of moving parts, binding
of moving parts, mounting and any other
conditions that may affect its operation. A
guard or other part that is damaged should be
properly repaired or replaced.
20. NEVER LEAVE THE TOOL RUNNING
UNATTENDED. TURN THE POWER "OFF".
Do not walk away from a running tool until
the blade comes to a complete stop and the
tool is unplugged from the power source.
21. DO NOT OVER-REACH.
Keep proper footing and balance at all times.
NEVER reach your hand or arm across the
path of the cutting blade.
22. MAINTAIN TOOLS WITH CARE.
Keep tools sharp and clean for best and
safest performance. Follow instructions for
lubricating and changing accessories.
23. WARNING: Dust generated from certain
materials can be hazardous to your health.
Always operate saw in well-ventilated area
and provide for proper dust removal.
I_,DANGER l
24. People with electronic devices, such
as pacemakers, should consult their
physician(s) before using this product.
Operation of electrical equipment in close
proximity to a heart pacemaker could cause
interference or failure of the pacemaker.
6