Craftsman 126.32561 Manual Del Operador página 24

33.9 o Bevel Adjustment
If necessary the 33.9 osettings can be
checked and adjusted. An angle gauge will
be required and this must be accurately set
to 33.90 .
To engage the Crown Molding Pin:
1. Pull the pin out slightly and rotate 1Aof a
turn in either direction (Fig. P)
2. Release the pin and tilt the Cutting Head
to the 33.90 setting
(Fig. P)
3. Check the angle of the blade against the
machine table using the angle gauge.
4. If adjustment is required loosen the
Iocknut to the 33.9 o socket head stop screw.
Adjust the screw in or out until the correct
bevel angle is achieved. (Fig. Q)
Retighten the Iocknut.
(Fig. Q)
Fence Adjustment
The fence must be aligned at 90o (square)
to a correctly installed blade The rotary table
must be set at '0 °' miter angle.
The Fence is fastened to the table with four (4)
socket head Allen screws that are positioned
two (2) at either side in elongated slots.
1. Place a combination square on the table
with the rule against the Fence and the heel
against the Blade. (Fig. R)
(Fig. R)
24