Foss Soxtec 2050 Manual Del Usuario página 42

6.5.1 Replacement of the Solvent Addition Connectors
1. Before any disassembling, disconnect incoming mains supply.
2. See Fig. 6:1. Remove the rear cover by unscrewing the eight screws (pos 1) and
washers (pos 2) and the three screws (pos 3) and washers (pos 4) at the rear.
3. Loosen the nut (pos 5) holding the connector (pos 6).
4. Change the connectors and nuts.
5. Assemble in reverse order.
6.5.2 Replacement of the Front Glass
1. Before any disassembling, disconnect incoming mains supply.
2. See Fig. 6:2. Remove the rear cover by unscrewing the eight screws (pos 1) and
washers (pos 2) and the three screws (pos 3) and washers (pos 4) at the rear.
3. Unscrew the eight screws (pos 5) holding the top and the half front part with an
Allen key, no. 2,5. Lift it a bit and loosen the line holding the front glass from
the wheel (pos 6).
4. Lift away the top and the half front part.
5. Loosen the knots on the line and change the front glass.
6. Assemble in reverse order.
7
8
6
5
Fig. 6:3 Replacement of the condensers
6:4
Soxtec™ 2050 Automatic System
1
3
2
11
4
User Manual 1000 7414 / Rev. 4
12
9
10
2050037c