Publicidad
Idiomas disponibles
Idiomas disponibles
Never wear loose jewellery, loose clothing or accessories (e.g. tie, scarf).
•
•
Do not work on the machine if you are tired, not concentrated or under the influence of
medication, alcohol or drugs!
•
Connect the machine to a suitable dust collection system.
Do not use the machine in areas where vapours of paints, solvents or flammable liquids
•
represent a potential danger (danger of fire or explosion!).
Do not smoke in the immediate vicinity of the machine (fire hazard).
•
Shut down the machine and disconnect it from the power supply, before adjustment,
•
changeover, cleaning, maintenance or repair work, etc. Before starting work on the
machine, wait until all tools or machine parts have come to a complete standstill and
secure the machine against unintentional restart.
•
Warning signs and/or stickers on the machine that are illegible or have been removed must
be replaced immediately!
12.5 Electrical safety
Only use suitable extension cables.
•
•
A damaged or tangled cable increases the risk of electric shock. Handle the cable with care.
Never use the cable to carry, pull or disconnect the power tool. Keep the cable away from
heat, oil, sharp edges or moving parts.
•
Proper plugs and outlets reduce the risk of electric shock.
•
Water entry into the machine increases the risk of electric shock. Do not expose the
machine to rain or moisture.
•
Before connecting the machine always make sure that the main switch is switches off.
Use the machine only when the ON-OFF switch is in good working order.
•
12.6 Special safety instructions for this machine
Wood dust is generated when operating the machine. Therefore, connect the machine to a
suitable dust and chip extraction system when installing it.
Always switch on the dust collection system before you start machining the workpiece.
Never remove sections or other parts of the workpiece from the cutting area while the motor is
running.
When using milling tools with a diameter ≥16 mm and circular saw blades, they must comply
with EN 847-1:2013 and EN 847-2:2013; tool carriers must comply with EN 847-3:2013.
Wear hearing protection certified to health and safety regulations to limit noise exposure.
Replace cracked and deformed saw blades immediately; they cannot be repaired.
Select the number of teeth of the saw blade so that at least 2-3 teeth cut through the
workpiece at the same time. A lower number of teeth leads on the one hand to an unclean
cut and on the other hand increases the risk of vibrations and noise pollution due to
increased kickback.
Observe the operating instructions for the TAS165PRO plunge saw.
12.7 Hazard warnings
Residual risks
Despite intended use, certain residual risk factors remain.
Risk of injury to fingers and hands from rotating saw blade if the workpiece is not guided
•
properly.
Risk of injury from the workpiece being flung away if not properly held or guided, such as
•
working without a fence. Risk of kickback!
Danger to health from wood dust or wood chips. It is essential to wear personal protective
•
equipment such as eye protection and a dust mask and to use an extraction system.
Risk of injury from breakage or ejection of the saw blade or parts of it, especially in the
•
event of overloading or incorrect direction of rotation.
Risk of injury to the eye from flying parts, even with protective goggles.
•
•
Hearing damage if hearing protection is not used.
Injuries caused by a defective saw blade.
•
•
Risk of electric shock, if improper electrical connections are used.
HOLZMANN Maschinen GmbH
www.holzmann-maschinen.at
SAFETY
31
VPS3216ECO_230V
Publicidad
