Dismantling/Assembling The Tool Holder - BDS Maschinen MAB 1300 Instrucciones De Manejo

Steel with low thickness
NF metals or workpieces with an uneven surface

Dismantling/assembling the tool holder

MAB 1300
When drilling into steel of low thickness, an additional steel plate
(minimum dimensions 100 x 200 x 20 mm) must be placed under
the workpiece. Secure the steel plate to prevent it from falling.
A special holding device must be used when drilling into NF me-
tals or into workpieces with an uneven surface.
NOTE
► BDS offers special clamping devices for tubes and non-
magnetic materials in its range of accessories.
Dismantling the tool holder
Unscrew and remove the screws of the retainer (3) on the
‹
magnetic foot.
Push the tool holder (2) out of the morse taper with the ejec-
‹
tor pin (G).
Remove the tool holder with the retainer.
‹
NOTE
► Keep the tool holder with retainer and screws in the trans-
port case for later use.
Assemble the tool holder
Insert the tool holder (2) from below into the morse taper (5)
‹
of the machine.
Put the retainer into the guide on the magnetic foot and
‹
secure it with the screws.
Preparation
49