BDS Maschinen MAB 1300 Instrucciones De Manejo página 59

Ocultar thumbs Ver también para MAB 1300:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Drilling with core drills
MAB 1300
When drilling with core drills, proceed as follows:
Assemble the tool holder and the retainer.
Use the ZAP 200 (A) reducing ring for core drills with 19mm
Weldon shank.
Connect the cooling lubricant system.
Insert the appropriate ejector pin into the core drill and insert
the core drill into the tool holder.
Place the machine at the working location, align it and switch
on the magnetic clamps.
Select a suitable speed and switch on the machine.
NOTE
Observe the following instructions when drilling with core drills:
Drilling with core drills does not require great effort. The dril-
ling process is not accelerated by higher pressure. The drill
wears faster and the machine can be overloaded.
Use the high-performance BDS 5000 cutting oil in the coo-
ling lubricant system of the machine.
The cooling lubricant system cannot be used when wor-
king overhead. In this case, use the high-performance ZHS
400 grease spray. Spray the drill on the inside and outside
before drilling. Repeat this procedure when drilling deeper
holes.
Pay attention to the production of shavings. In the case of
larger drilling depths, break shaving regularly.
Operation
59

Publicidad

Tabla de contenido
loading

Tabla de contenido