Operation
Activating/deactivating the magnetic clamp
Switching machine ON/OFF
MAB 1300
Activating the magnetic clamp
CAUTION
►
Switch on the magnetic clamp only when the machine is
standing on a magnetic substrate to prevent the magnet
from overheating.
Turn on switch (22). The indicator lamp in switch (22) lights
up.
Check the magnet clamping force in the magnet indica-
tor (24). If the magnet clamping force is sufficient, the MAG-
NET POWER indicator lamp (24) is green. If the MAGNET
POWER indicator light (24) is red, sufficient magnet clam-
ping force is not available.
CAUTION
►
The maximum magnet clamping force is only available after
switching on the motor.
Deactivating the magnetic clamp
Hold the handle tightly (12) to stop the machine from slip-
ping.
Turn off switch (22). The indicator lamp in switch (22) goes
out.
Turn the machine ON using the ON/OFF switch (21) with the
green button (I) and OFF with the red button (O).
NOTE
►
The machine can only be switched on when the magnetic
clamp has been switched on.
►
Allow a severely overheated machine to run on at idle speed
for approx. 2 minutes to cool it down.
►
The machine switches off automatically in the event of a
power failure or if the magnetic clamp is switched off.
Operation
55