Inserting The Tool; Safety Precautions - BDS Maschinen MAB 1300 Instrucciones De Manejo

Preparation

Inserting the tool

Safety precautions

50
The machine is equipped with an MK tool holder. Depending
on the type of tool to be used, corresponding tool holders, drill
chucks or adapters must be employed.
Tool
Tools with
32 mm Weldon shank
Tools with
19 mm Weldon shank
Tool with
MK4 taper
Tool with
MK3 taper
Tools with
straight shank
drill taps
WARNING
Risk of injury!
► Do not use damaged, soiled or worn tools.
► Carry out tool changes only when the machine is switched
off and at a standstill. Remove plug from the mains socket.
► After inserting, check that the tool is engaged securely.
► Only use tools, adapter and accessories that match the
machine.
tool holder to be used
Use MK4/Weldon 32mm tool holder with
retainer (delivery condition).
Use ZAP 200 reducing ring.
Insert the tool directly into the morse taper
(5). Dismantle the tool holder with the
retainer.
Use adapter sleeve (available as an
accessory). Dismantle the tool holder with
the retainer.
Use drill chuck with tapered mandrel
(available as an accessory). If necessary,
use an adapter sleeve.
Use industrial tool holder with Weldon
Shank and matching ZGA adapter for drill
taps (available as an accessory).
MAB 1300