Ingeteam INGECON SUN 3TL Manual De Instalacion Y Uso página 15

Receipt of the unit and storage
3. Receipt of the unit and storage
3.1. Reception
Keep the unit in its packaging until immediately before installation.
3.2. Unit identification
The serial number of the unit is its unique identifier. You must quote this number in any communication with
Ingeteam.
The unit's serial number is marked on the specifications plate.
3.3. Transport damage
If the unit has been damaged during transport, proceed as follows:
1. Do not proceed with the installation.
2. Notify the distributor immediately within five days of receipt of the unit.
If ultimately the unit has to be returned to the manufacturer, the original packaging must be used.
3.4. Storage
CAUTION
Failure to follow the instructions in this section may lead to damage to the unit.
Ingeteam accepts no liability for damage resulting from the failure to follow these instructions.
If the unit is not installed immediately after reception, the following points should be taken into account in order to
avoid damage:
• The unit must be stored upright in the original packaging. Stacking is not permitted.
• Keep the unit free of dirt (dust, shavings, grease, etc.) and away from rodents.
• Keep it away from water splashes, welding sparks, etc.
• Cover the unit with a breathable protective material in order to prevent condensation due to ambient
humidity.
• Units in storage must not be subjected to weather conditions other than those indicated in section
Specification table".
• It is very important to protect the unit from chemical products which can cause corrosion, as well as from
salty atmospheres.
• Do not store the unit outdoors.
3.5. Conservation
In order to permit correct conservation of the units, they must not be removed from their original packaging until it
is time to install them.
In case of prolonged storage, use dry places, avoiding, as far as possible, sharp changes in temperature.
Deterioration of the packaging (tears, holes, etc.) prevents the units from being kept in optimum conditions before
installation. Ingeteam accepts no liability in the case of failing to observe this condition.
ACL2011IQM01_ - Installation and Operation Manual
Ingeteam
"2.8.
EN
ES
FR
IT
PT
15