GE ZDP366NP2SS Instrucciones De Instalación página 13

Installation
STEP 3 INSTALL ANTI-TIP DEVICE
• All ranges can tip.
• BURNSor other SERIOUSINJURIES
can result.
INSTALL and CHECK the ANTI-TIP
bracket following these instructions.
To reduce the risk of tipping the range, the range must
be secured by a properly installed anti-tip bracket. See
installation instructions shipped with the bracket
for complete details before attempting to install.
To check if the bracket is installed and engaged properly,
look underneath the range. The anti-tip bracket should be
inserted into the opening on the anti-tip brace on the
range. If the bracket arm misses the brace to the left or
right, or the bracket arm is not protruding through the
brace opening, the bracket must be reinstalled.
If the range is pulled from the wall for any reason, always
repeat this procedure to verify the range is properly
secured by the anti-tip bracket.
If your range has no anti-tip bracket, call 1.800.626.8774
to receive one at no cost.
If the anti-tip device supplied with the range does not fit this
application, use the universal Anti-Tip Device WB2X7909.
Read the AHAIVlAnti-Tip Safety Brochure packed with
the bracket.
Anti-Tip Parts Provided
4 WoodScrews
3 HexHeadScrews
(2 required,1 extra)
Anti-TipBrace
Anti-TipBracket
AHAM Anti-Tip
Safety Brochure
• Attach the anti-tip brace onto the bottom of the
range in the recessed area. Install 2 hex screws
(provided) through the brace and into the range.
NOTE: This anti-tip device mag be installed on the
opposite side of the range.
HexScrews
Anti-TipBrace
AlternateBrace
Position
• Measure and mark Dimension A (see table below)
from the left (or right) side of the installation
location. If the countertop has an overhang,
add that dimension to Dimension A.
• Place the anti-tip bracket against the floor and
back wall at the marked location. Mark screw holes
for fastening the bracket to the wall sole plate and
the floor.
• Drill 1/8" pilot holes at a 20 ° angle.
• Secure the bracket to the wall and/or floor with
at least 2 wood screws (provided).
For Concrete or Cement Construction: You must
use appropriate fastening hardware (not provided).
Ra.ge A Anti-Tip Bracket
30" 5-1/16" !
36" 5-1/16" Wall SolePlate
/
48" 8-1/4"
...... !
13