Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
for Gas Conversion
CHANGE BURNER ORIFICES (cont.)
IMPORTANT: Find your model number below Read
each orifice label to identify and install them in the
exact locations shown.
ZDP304 SIMMER ORIFICES
A 34SL or 51SN orifice
will be used on all burners.
ZDP304 MAIN ORIFICES
_2864HX_N°rrifice"
_
L_
will be used
on these three
burners.
Use Cl 108XL
or 190XN orifice
for the right
front
burner.
ZDP364,
ZDP366,
ZDP484,
ZDP486
SIMMER
ORIFICES
MAIN
ORIFICES
I_
_!
A 34SL or 51SN orifice
will be used on all
burners.
r @
Use 108×L or
190×N orifices
for all
burners.
A. Return the unused orifices to the holder. Reattach
the holder and the instruction sheet with screw
in the original storage location.
B. Replace the burner heads, caps and top grates.
On range models,replace rear vent trim.
CHANGE GRILL ORIFICE
(if present}
Locate the 1-1/2" long Grillorifice.
Selectfor your gas type. LP--.047, NAT--.067
A. Removethe grill cover,
grates and grate frame. Lift
the radiant baffle straight
up and off.
B. Removethe 2 hex
head screws from
the top of the igniter.
• Removeone screw
from each side of
the burner surround.
• Lift out the surround.
C°
D°
Carefully push the
igniter (]side and
under
the burner.
Do not pull or pinch
the wire.
Remove/4burner
attachment screws,
2 at the front and 2
at the back. Slidethe
burner assembly
toward the back and
out of the gas inlet.
Usea 1/2" deep well
socket to remove
and replace the orifice.
Reversethese
steps to re-(]ssemble
the grill. Be sure to
place the unused
orifice in the holder
for possible future use.
lUUUU UUUUUUlIIIIIII UUUUl
Remove
2-
hexhead_ _
_ --,
screws
I
J
/
!
Surround
Screws
Burner
Igniter
Surround
Assembly
Frontof Range
22
Publicidad
