Publicidad
Idiomas disponibles
Idiomas disponibles
ZX12B30PSS, ZX12B36PSS, ZX12B48PSS Accessorg Installation
OPTIONAL ACCESSORIES--12"
HIGH BACKSPLASH
AWARNING:
To prevent ignition of combustible
materials,
the entire back wall above the range must
be protected
bg a backsplash
constructed
of non-combustible
material.
This stainless steel backsplash
accessorg
must be installed in combination
with a custom,
non-combustible
backsplash
built beLlond
the 12" height of the backsplash.
BEFORE YOU BEGIN
Read these instructions
completelg
end cnrefullg.
IMPORTANT: Seve these instructions
for Iocel
inspector's
use.
IMPORTANT: OBSERVE ALL GOVERNING CODES
AND ORDINANCES.
NOTE TO INSTALLER: Be sure to leave these
instructions
with the Consumer.
NOTE TO CONSUMER: Keep these instructions
with sour Owner's
Mnnunl for future
reference.
This kit provides for the instellntion
of n 12" high
bncksplnsh
for 30", 36" or 48" Monogrnm
Professionel
Renges end Rengetops.
• Pencil
This Kit Includes
TOOLS AND MATERIALS REQUIRED
• Gloves to protect against sharp edges
• T-15 and #2 Phillips screwdrivers
Wall
Support
• Drill with 3/32" and 9/64" bits
Panel
•" SafetgLevel
glasses
• Wall support
panel
• Cover panel
• Hardware package with
- 5 Stainless Steel Torx 15 #8
self-tapping
screws
- 5 Phillips #2 pan head wood
#10 screws
Hardware
Package
INSTALL 12" BACKSPLASH
.4,WA RN ING: This
b acksplash
must
be securelg fastened
to the wall. Failure to do
so could result in damage
or personal
injurg.
• Install and level the range or rangetop and the
range hood according to the installation
instructions.
• Remove the backsplash packaging and
protective film.
• Use a level to pencil a horizontal line on the wall,
1/8" above the range or rangetop. The 1/8" gap
allows the cover panel to overlap the wall support
panel.
• Locate wall studs on each side. Where studs are not
available, plan to use wall anchors (not provided).
• Align the wall support panel on the marked
horizontal line and centered left to right.
• The wall support panel must be secured to the wall
at all 4 corners. Use wood screws (provided) or wall
anchors (not provided) to secure the support panel
to the wall.
• Place the cover panel over the wall support
panel and secure with Torx screws (provided).
Install 2 screws on each side.
/8 :r--
Install4 Wood
Screws
Wall Support
Panel
Wall
Support
Panel
CoverPanel
.... _
InstallT-15
o_" Screws
18
Publicidad
