Publicidad
Idiomas disponibles
Idiomas disponibles
ZXADJB30PSS,ZXADJB36PSS, Z XADJB48PSSAccessorg Installation
ACCESSORIES--30"
TO 36" ADJUSTABLE BACKSPLASH (not included)
- WARNING:
To prevent ignition of combustible
materials,
the entire back wall above the range must
be protected
by a backsplash
constructed
of non-combustible
material.
BEFORE YOU BEGIN
Read these instructions
completely
and carefully.
IMPORTANT: Save these instructions
for local
inspector's
use.
IMPORTANT: OBSERVEALL GOVERNING CODES
AND ORDINANCES.
NOTE TO INSTALLER: Be sure to leave these
instructions
with the Consumer.
NOTE TO CONSUMER: Keep these instructions
with your Owner's Manual for future reference.
• This backsplash adjusts to fit the space between
the top of the range and the bottom of the hood,
from 30" Min. to 36" Max. height.
• Maximum shelf load-bearing weight is 40 Ibs.
TOOLS AND MATERIALS REQUIRED
• Gloves to protect against sharp edges
• T-1S and #2 Phillips screwdrivers
• Drill with 3/32" and 9/64" bits
• Safety glasses
• Level
TopCover
• Pencil
with Shelf
TopWall
Support
This Kit Includes
• Top wall support
• Bottom wall support
• Top cover with shelf
• Bottom cover
• Hardware package with
BottomWall Support
- 9 Stainless Steel Torx 15 #8
self-tapping screws
- 9 Phillips #2 pan head wood #10 screws
- 3 Stainless Steel #2 truss head
#10 screws (for alternate
installation method)
Hardware
Package
INSTALL THE WALL SUPPORT PANELS
WARNING:
The wall support
panels
must
be securely
fastened
to the wall.
Failure
to
do so could
result
in damage
or personal
injury.
IMPORTANT: T his backsplosh is designed to cover the wall
between the bottom of the hood and the top of the range.
The vent hood should be installed over the rongetop or
range before installing this backsplGsh.
• Install and levelthe Ronge/Rongetop according
to the product installation instructions.
• Removebocksplosh packaging and protective film.
• Locate wall studs on each side. Where studs ore not
available, plan to use wall anchors (not provided).
• Use a level to pencil 2 horizontal lines on the wall,
one 3_/8" b elow the vent hood and the other 1/8" above
the Range/Rangetop.This 1/8" space allows the cover
panels to overlap the wall supports.
• Secure the top wall support panel to the wall with 4 wood
screws, through the outermost studs.
• Use 4 wood screws to secure the bottom wall support
panel. The center slot should be positioned at the top.
The gap between the top and bottom support panels
will be covered bg the top cover with shelf.
Securethe top
panelto the wall
with 4 wood
screws
Wood
Screws
Secure
the bottompanel
to the wall with
4 wood screws
19
Publicidad
