GE ZDP366NP2SS Instrucciones De Instalación página 2

Installation Instructions
BEFORE YOU BEGIN
Readthese instructions completely and carefully.
•
IMPORTANT-
Savethese instructions for local
inspector's use.
•
I M PORTANT-Observe
all g overning codesand
ordinances.
•
Note to Installer-
Be sure to leave these instructions
with the Consumer.
° Note to Consumer- Keepthese instructions
with your Owner's Manual for future reference.
• Completion Time- i to 3 hours.
• Proper installation is the responsibility of the installer.
Product failure due to improper installation is not covered
under the warranty. SeeOwner's Manualfor warranty
information.
- WARNING:
This appliance must be properly grounded. See"Electric
Supply."
For Monogram local s ervice in your area, 1.800.444.1845.
For Monogram Service in Canada, call 1.800.561.3344.
For Monogram Parts and Accessories,call 1.800.626.2002.
If you received a damaged range, you should contact your
dealer.
In the Commonwealth of Massachusetts:
• This product must be installed by a licensed plumber or gas
fitter.
• When using ball type gas shut off valves,they shall be
T-handle type.
• A flexible gas connector, when used, must not exceed
3 feet.
-AWARNING:
All ranges can tip. Injury could result. Install the
supplied Anti-Tip Bracket provided. See instructions
in this manual or with the bracket.
If sold outside the U.S.and Canada:
-AWARNING:lfyou w ish t o
use this product
with
Liquefied Petroleum (LP)gas containing greater than 10%
butane, you must purchase the butane conversion kit
#WB28K10589. To order, please call 1.888.664.8403
or 1.787.276.4051.
Vent hood Combinations:
It is recommended that these ranges be installed
in conjunction with a suitable overhead vent hood.
• Install a hood with at least 1200 CFMabove a 48"
wide range.
• Install a hood with at least 600 CFMabove a 30"
or 36" range.
Dueto the high heat capacity of this unit, particular attention
should be paid to the hood and ductwork installation to
assure it meets local building codes.
-AWARNING:
Clearancesto horizontal surfaces above the range,
measured to the cooking surface:
• Installations without a hood require 48" minimum
to combustibles.
• A custom hood installation with exposedhorizontal
combustibles surfaces must have an Auto-On feature.
• For other installations with a hood, refer to hood installation
instructions for specific hood clearances.
- CAUTION:
These ranges weigh up to 700 pounds. Somedisassembly
will reduce the weight considerably. Due to the weight and
size of the range and to reduce the risk of personal injury
or damage to the product:
TWO PEOPLE AREREQUIRED FORPROPER INSTALLATION
OF36" AND 30" RANGES.
THREE PEOPLE AREREQUIRED FORPROPER INSTALLATION
OF48" RANGES.
Leaktesting of the appliance shall be conducted according
to the manufacturer's instructions.
Installation must conform with local codes. In the absence
of local codes,the range must comply with the National Fuel
Gas Code,ANSIZ223.1/NFPA 54, latest edition and National
ElectricalCode ANSI/NFPA 70 latest addition. In Canada,
installation must conform with the current Natural Gas
Installation Code,CAN/CGA-B149.1or the current Propane
Installation Code,CAN/CGA-B149.2, a nd with local codes
where applicable. This range has been design-certified by
CSAInternational according to ANSIZ21.1,latest edition and
Canadian Gas Association according to CAN/CGA-I.1 latest
edition.