Publicidad
12. Do not allow children to play with door controls. Keep remote controls away from children. Watch the
moving door and keep people away until the door is completely opened or closed.
13. Take care when operating the manual release since an open door may fall rapidly due to weak or broken
springs or being out of balance.
14. Frequently examine the installation, in particular check cables, springs and mountings for signs of wear,
damage or imbalance. Do not use if repair or adjustment is needed since a fault in the installation or an
incorrectly balanced door may cause injury.
15. Each month check that the drive reverses when the door contacts a 50 mm high object placed on the
floor. Adjust if necessary and recheck since an incorrect adjustment may present a hazard, for drives
incorporating an entrapment protection system depending on contact with the bottom edge of the
door.
16. Details on how to use the manual release.
17. Information concerning the adjustment of the door and drive.
18. Disconnect the supply when cleaning or carrying out other maintenance.
19. The installation instructions shall include details for the installation of the drive and its associated
components.
IMPORTANT SAFETY FOR BUTTON CELL BATTERY
WARNING
THIS PRODUCT CONTAINS A BUTTON CELL BATTERY
The battery is hazardous and must be kept out of reach of children.
The battery can cause severe or fatal injuries within 2 hours or less if swallowed or placed inside any part of the
body.
If you suspect the battery has been swallowed or placed inside any part of the body, SEEK
medical attention.
Transmitter Battery Replacement
Remove the fixing screws located on the underside of the Hand-Held Transmitter.
Open the 2 halves of the Transmitter shell and replace the battery with one of identical specification.
Test that the Red Coloured Indicator lamp illuminates when one of the Transmitter buttons is pressed and then
replace the fixing screws.
Wall Switch-Wireless Battery Replacement
Remove the cover plate while the unit is still mounted to the wall by sliding and twisting a straight screwdriver
in the slot provided on the top and underside of the wall
Use a small Phillips Head Screwdriver remove the 4 screws holding the switches in place.
Replace the battery with one of identical specification.
1. Obstruction force adjustment
The minimum force display "1" and it can be adjusted upward. Display "5" means the maximum force.
2. Travel speed adjustment
"8" appears on the display means the 80% of the travel speed. Display "A" means the full speed 160mm/s or
200mm/s.
3. Reversal height adjustment
"0" appears on the display means the door will rebound to the top. Display "1~9" means the door will rebound
PRODUCT DESCRIPTION & FEATURES
EN
plate.
IMMEDIATE
Publicidad
