Publicidad
EN
C. PASS DOOR SWITCH TYPE SETTING
a) Press and hold SET Buton un�l "1" appears
on the display, next press the UP buton un�l
"C" appears on the display to enter this
func�on se�ng then release the buton.
b) Press the SET buton again. The unit is now
in the pass door switch type adjustment
mode. And then you will see a figure "0" with
flash dot appears on the display.
c) Press UP / Down buton once to set the
pass door switch type. You can choose "0" or
"1" set.
Figure "0" means, the pass door func�on is
normally open.
Figure "1" means, the pass door func�on is
normally close.
d) Press SET buton to confirm the set and it
will back to standby status automa�cally and
display "ll".
NOTE: The pass door switch is set on "0"as
standard in factory.
Publicidad
