Publicidad
EN
d. PHOTOCELL ON/OFF SETTING
NOTE: Make sure the photocell has been
correctly installed and use
Normally Closed contacts to the accessory
terminals of the opener (Fig.22, Fig.23)
Also note that the photo beam func�on must be
disabled if NO photo beams are fited, otherwise
the door cannot be closed, and the LED display
will show the leter "r" as an indica�on.
a) Press and hold SET Buton un�l "1" appears on
the display, next press the UP buton un�l "d"
appears on the display to enter this func�on
se�ng then release the buton.
b) Press the SET buton again. The unit is now in
the photocell ON/OFF adjustment mode. And
then you will see a figure "0" with flash dot
appears on the display.
c) Press UP / Down buton once to set the
photocell ON/OFF switch. You can choose "0" or
"1" set.
Figure "0" means, the photocell func�on is
closed.
Figure "1" means, the photocell func�on is open.
d) Press SET buton to confirm the set and it will
be back to standby status automa�cally and
display "ll".
NOTE: The photocell is set on "0"as standard in
factory.
Publicidad
