OPEN / STOP / CLOSE TERMINALS
The O/S/C facility can be used for an external push buton switch to operate the opener. The switch must have
voltage free normally open NC contacts (Fig. 22
Photo beam connection (optional) – Fig. 22, Fig. 23
Switch control connection (optional) – Fig. 22
Remark:
1. Flash (Caution Light) should be less than 10W.
2. PB (External Push Button) should be "NO" contact.
EN
For mul�ple func�on motor:
a) Press and hold SET Buton un�l "
on the display, next short press the DOWN buton to
choose the "0"func�on.
b) A�er short press SET buton, the display will show
"
" , and the red dot in the lower right corner is
flashing.
c) Next, short press UP/DOWN buton to choose the
func�on "0" or "1".
"0" is as standard in factory default, the motor
reversal func�on is closed. "1" means the motor
reversal func�on is open, the door will move
backward.
d) Then short press SET Buton to confirm the
func�on you need.
Remark: You need to reset the travel limit a�er you
choose this func�on.
" appears