Publicidad
EN
8. PARTIAL OPEN/HEIGHT SETTING
a) Press and hold SET Buton un�l "1" appears
on the display, next press the UP Buton un�l
"8" appears on the display to enter this
func�on se�ng then release the buton.
b) Press the SET buton again, the unit is now
in par�al open/height adjustment mode. And
then you will see a figure "0" with flash dot
appears on the display.
c) Press UP/Down buton once to select if you
the
func�on or set
want to open
par�al open
the
height.
(0 -C). Press UP
par�al open
buton to increase , or DOWN buton to
decrease.
Figure "0" means close the par�al open
func�on.
Figure "1" means the height is 2cm.
Figure "2" means the height is 4cm.
Figure "3" means the height is 8cm
Figure "4" means the height is 12cm
Figure "5" means the height is 20cm
Figure "6" means the height is 40cm
Figure "7" means the height is 60cm
Figure "8" means the height is 80cm
Figure "9" means the height is 100cm
Figure "A" means the height is 120cm
Figure "B" means the height is 140cm
Figure "C" means the height is 160cm
d) Press SET buton to confirm the set and it
will back to standby status automa�cally
and display "
".
1 – Increase
NOTE:
2 – Decrease
1. The par�al open/height is set on "0" as
standard in factory.
2. If you open the par�al open/height
func�on, the buton's recogni�on func�on will
be disabled.
3. Other details please refer to the Instruc�on
manual of the remote carefully.
4. If you enabled the partial open function
then disabled this function later, please notice
that only the coded button you leaned in the
beginning can control the opener now.
Publicidad
