Publicidad
Idiomas disponibles
Idiomas disponibles
Please be sure that the tension levels are adequate for the equipment,
an that the electrical installation as well as the grounding, are in perfect shape.
4.2. ATTACHMENT
In the back of the PowerNET P-600 there is a hook utilized to attach the
equipment to a panel or pole.
4.2.1. PANEL ATTACHING
To attach to a panel, use a screw leaving a space between surfaces, as to allow
the equipment hook to be hanged on the screw.
4.2.2. POLE ATTACHMENT
Place the attachment strap or support on the pole. Fix tight the support and be
sure that is securely fixed in place. Insert the PowerNET P-600 back hook into the
support utilizing straps or screws, according to the attachment fastening system.
The PowerNET P-600 must be installed in a vertical position, with the connectors directed
toward the floor. The cables must be positioned with a gap between the electrical network
connection and the equipment forming a "U" or "Belly" avoiding this way any possible water
4.3. STAR OR DELTA DIRECT TENSION CONNECTION
The PowerNET P-600 has two internal circuits for measurement: one for delta
and one for star. It is not necessary to switch the cables A, Band C to change the
connection type; this is done through the equipment programming.
Connect the cables with the rings identification according to the drawing below to
connect directly to the electrical network, connect first the cable identified by the letter
N (common).
PowerNET P-600
Illustrative picture
ATTENTION
entering by capillary effect. .
Manual de Instalación y Operación
107
Publicidad
