IMS PowerNET P-600 Manual De Instalación Y Operación página 131

7.12.1 MEMORY, START STOP AND CLEANING.
In the memory screen it is possible to use the keys for start, stop and clean
the memory from registries:
Start the registry in memory
v Press the key "Start".
v When showing the message "Start Registry? <F4>", the screen insert
NUC (customer number) will show".
v Confirm with key F4.
Stop the registry in memory
v Press the key "Stop".
v When showing the message "Stop Registry? <F4>".
v Confirm with key F4.
Clean the registry memory
v Press the key "Leave".
v When showing the message "Clean Memory? <F4>".
v Confirm with key F4.
Obs.: When the equipment is registering, no command to enter in
configuration mode, clean memory, or visualize version will be accepted.
7.13. VALID AND INVALID REGISTRIES
In the memory screen Y, to see the number of valid and invalid registries press
once again the key Memo. This screen indicates the memory valid and ivalid registries
number.
The amount of valid registries necessary for data analysis is defined by the
ANEEL.
TN
Total de Registros = Registries Total
Valido = Valid
Invalido = Invalid
To return to the memory screen press once again the key Memo.
The image below shows an example in hiwch the equipment is registering
with a registry interval equal to 1 minute .with a percentage limit for increase
sinking of the nominal tension equal to 10%, time interval
invalid equal to 3 seconds and Interruption percentage also equal to 10% nominal
tension .
PowerNET P-600
Manual de Instalación y Operación
and
131