Publicidad
Idiomas disponibles
Idiomas disponibles
v Utilize the increase or decrease keys to adjust the desired value for this variable.
v To confirm and go to the next parameter press F1.
v To leave press F6.
CT Second: (Current transformer secondary)
v
Utilize the increase or decrease keys to adjust the desired value for this variable.
v To confirm and go to the next parameter press F1.
v To leave press F6.
Elements: (Current Elements number)
v
Utilize the increase or decrease keys to define 3 CT's or 2 CT.
v To confirm and go to the next parameter press F1.
v To leave press F6.
It is usual in industrial installations utilize 2 CT 's for measurement , this
function allows to connect CT 's Adapter in the CT 's installation secondary when
there are not 3 CT 's present.
For sensors sets clamp type with Mobile or flexible core, this parameter is
defined as 3 CT's, although it is possible the use of only 2 sensors.
Phases Num.: (Consuming Unit phases number)
v
Utilize the increase or decrease keys to define the phases number of the
consuming unit.
v To confirm and go to the next parameter press F1.
v To leave press F6.
Percentage: (Nominal tension tolerance for Valid or invalid registries)
v
Utilize the increase or decrease keys to define the nominal tension percentage for
this event.
v To confirm and go to the next parameter press F1.
v To leave press F6.
ANEEL Requirements for Resolution 505
The tension measurement must correspond with the connection type of the
consuming unit – monophasic (1), biphasic (2) or triphasic (3), spanning measurements
Between all phases and between all phases and the neutral, when available. Are
considered as valids or invalids registries the tension phases configured according a
consuming unit, no matter the other phase's measurement.
Phases number
PowerNET P-600
Measurement Considered
1
2
3
Chart 3
Installing and Operating Manual
A
A and B
A, B and C
116
Publicidad
