Angelo Po 0N0FAA Manual De Uso página 147

REPLACING PARTS
INSTRUCTIONS AND WARNINGS FOR PART REPLACEMENT
NOTE: Read the following section of the
"user instruction manual" carefully before re-
placing any part:
– Hazards and safety provisions during installa-
tion and commissioning, adjustments and part
replacement.
WARNING: Before carrying out any re-
placement procedure, activate all the safety
devices provided and decide whether staff at
work and those in the vicinity should be prop-
erly informed.
In particular, close the gas supply tap and pre-
vent access to all devices which might cause
unexpected hazards and damage to people's
health and safety if activated.
REPLACING THE TOP BURNER NOZZLE (Ø 80 - 4 KW)
To carry out this operation, proceed as follow.
Turn off the gas supply
1)
tap.
Remove the grid (A).
2)
Extract the burner (B).
3)
Unscrew the nozzle (C)
4)
and replace it with the one
suitable for the type of gas
in use (see table at back of
manual).
Replace the burner and
5)
the grid.
3319961_inst_GB_rev.1
REPLACING PARTS
A
When replacing worn parts, use original spare
parts only.
The manufacturer declines all responsibility
for injury or damage to components result-
ing from the use of non original parts, or ex-
traordinary work on the appliance which may
modify the safety requirements without the
manufacturer's authorisation.
When ordering components, follow the in-
structions provided in the spare part cata-
logue.
B
ENGLISH
8
C
15