Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
HAZARDS AND SAFETY PROVISIONS DURING INSTALLATION AND
COMMISSIONING, ADJUSTMENTS AND PART REPLACEMENT
During appliance installation, commissioning, adjustment and part replacement procedures,
watch out for the following hazards and provide for the countermeasures indicated below.
► Source of hazard: Appliance mechanics
Hazard
Risk of crushing parts
of the body in case of
tip-over or fall of the
appliance
Risk of cutting due
to sharp edges
Risk of crushing parts
of the body in case of
fall of the appliance
► Source of hazard: Environment in which the appliance is used
Hazard
Concentration
of
burnt gas emissions
due to an incorrect
installation
and/or
adjustment of the
gas system
Increase of working
temperature of com-
ponents
Concentration
of
burnt gas emissions
due to an incorrect
installation
6
Where or in which situations
does the hazard occur?
When the appliance is lifted • Pay attention to the cen-
When handling sheet-metal
parts
In case of uneven or sloped
fl oors
Where or in which situations
does the hazard occur?
In the event of inadequate
room ventilation; air and
vapour extraction fault;
incorrect installation, un-
suitable injector and/or pri-
mary air regulation
In the event of inadequate
room ventilation; air and
vapour extraction fault;
incorrect installation, un-
suitable injector and/or pri-
mary air regulation
In the event of inadequate
room ventilation; air intake
fault
Countermeasures
tre of gravity
• Avoid collisions
• Pay special care during
this activity
• Wear personal protective
equipment in accordance
with safety regulations
• Comply with the correct
installation requirements
as per section "Installing
the appliance" on page 10
of the installation manual.
Countermeasures
• Comply with the correct
installation requirements
as per section Installing
the appliance on page 10
of the installation manual.
• Comply with the correct
installation requirements
as per section Installing
the appliance on page 10
of the installation manual.
• Comply with the correct
installation requirements
as per section Installing
the appliance on page 10
of the installation manual.
SAFETY
Safety device
None
• PPE as required
by the applica-
ble laws in the
country of use.
• PPE as required
by the applica-
ble laws in the
country of use.
Safety device
See
section
(safety devic-
es on page 8)
See
section
(safety devic-
es on page 8)
See
section
(safety devic-
es on page 8)
3319961_ut_GB_rev.1
Publicidad
