honle SteriWhite Air Q330 Manual Del Usuario página 56

English
Faults
3.5.4 Reset operating hours
Fig. 36: Reset button (opening
next to LEDs)
3.6 Faults
3.6.1 General information
3.6.2 Fault list
Fault description
LEDs of the operating hour display do not
light up
56
The unit is connected to the power supply and switched on.
1. The operating hours counter can only be reset while the
unit is switched on.
If you have replaced a lamp and have just switched
the unit on again, the lamp will take approx. 3 minutes
to reach its full power.
Use this time to reset the operating hours.
2. The Reset button is located in the opening next to the
operating hour display.
To press the button, you will need a long, thin object.
3. Hold the Reset button pressed for approx. five sec-
onds.
ð Die LEDs flash alternately red and green three
times.
4. Release the Reset button.
ð The operating hours are reset to zero.
The LEDs now light up continuously in green again.
The following section contains information on possible mal-
functions, their causes and how to remedy them.
If a fault which cannot be remedied using this manual arises,
contact the manufacturer's or specialist dealer's customer
service department.
The contact information of the manufacturer can be found on
the last page of the manual.
Cause
Mains power plug is not
plugged in
On-Off switch not pressed Press the On-Off switch
Power outlet is
de-energised
SteriWhite Air Q330/Q600
Remedy
Check mains power plug
Check fuses