CASO DESIGN Beer Master Manual Del Usuario página 13

Transport inspection
WARNING

Do not allow children to play with packaging materials due to risk of su ocation.
PLEASE NOTE

Examine the shipment to ensure the unit and manual are included and inspect the
unit for any visible damage.

Immediately notify the carrier and/or the supplier about an incomplete shipment
or any damage as a result of inadequate packaging or mishandling.
Setup location requirements
In order to ensure the safe and trouble-free operation of the device, the setup location
must ful l the following prerequisites:
•
The device must be set up on a rm, at, horizontal surface with su cient load-be-
aring capacity.
•
Do not leave the ice maker to direct sunlight.
•
Ensure that there is su cient distance to strong heat sources such as hobs, heating
pipes, etc.
•
Choose the setup location in such a way that children cannot reach any hot surfaces
on the device.
•
The device is not intended to be installed in a wall or a built-in cupboard.
•
Do not set up the device in a hot, wet or extremely damp environment or near am-
mable material.
•
WARNING! Do not close the ventilation openings in the device housing.
•
The device requires an adequate ow of air in order to operate correctly. Make sure
that the back of the device is at least 12 cm away from the wall. Keep 10 cm free space
at the other sides of the device.
•
Ensure that the power cable does not hang down over a table or counter edge.
•
The electrical socket must be easily accessible so that the power lead can be discon-
nected easily, in the case of an emergency.
•
The installation and assembly of this device in non-stationary setup locations (e.g.
on ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following inst-
ructions must be observed for the electrical connection:
•
Before connecting the device, compare the connection data (voltage and frequen-
cy) on the rating plate with those of your electrical network. This data must agree in
order that no damages occur in the device. If in doubt, ask your quali ed electrician.
•
The electrical outlet must be protected by a 16A safety cut-out switch, separately
from other electricity consumers,
•
The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of re that is involved with this.
CASO Beer Master 13